Roof Tie Off Requirements

Osha tie off requirements guide applied technical services is incredibly proud to be an industry leader in all osha tie off inspections and related services.

Roof tie off requirements. With regard to fall protection requirements applicable to the construction work itself 1926 501 b 10 low slope roofs requires conventional fall protection a combination of a monitoring system and warning line or on roofs of 50 feet or less in width a monitoring system alone i e without a warning line be used. Basically everyone falls under osha 1926 standard now. Under the standard the requirement for fall protection for this work does not depend on the duration of the fall hazard exposure. Lay headers sheets of roofing or other materials no closer than 5 feet inside the edges of the roof and parallel to the roofline.

In regards specifically to roof fall protection the 1910 standard specifies for low slope roofs that when work is performed less than 6 feet 1 6 m from the roof edge the employer must ensure each employee is protected from falling by a guardrail system safety net system travel restraint system or personal fall arrest system. That all changes in june when this new directive goes into effect. Place warning lines and headers around the entire roof perimeter. As with most governing bodies osha has some very specific requirements regarding how where and when tie off systems and other safety measures must be used to help create a safe working.

Install warning lines no closer than 5 feet inside the roof edges and at a height of 34 to 45 inches.